BRP SEA-DOO GTI 130 2019, Operator'S Manual

Page: 128 / 204

MAINTENANCE PROCEDURES
All Other Countries
XPS™ RECOMMENDED ENGINE OIL
900 ACE
130 and 155
230
4T 5W40 SYNTHETIC
BLEND OIL
(P/N 779133)
If THE RECOMMENDED XPS
ENGINE OIL IS NOT AVAILABLE
Engine
without
supercharger
Use a 5W40 4-stroke
SAE synthetic engine oil
meeting or exceeding
the following lubricant
industry specifications:
– API service
classification SJ, SL,
SM or SN
Always check the API
service label certification
on the oil container,
it must contain at least
one of the indicated
standards.
Engine with
supercharger
Use a 5W40 4-stroke
SAE
motorcycle engine
oil compatible with
wet clutches
meeting
or exceeding the both
following lubricant
industry specifications:
– JASO-MA2
– API service
classification SJ, SL,
SM or SN
Always check the API
service label certification
on the oil container,
it must contain at least
one of the indicated
standards.
Rotax ® engines were developed and
validated using the XPS™ oil. BRP rec-
ommends the use of its XPS engine oil
or an equivalent at all time. Do not add
any additives to the recommended en-
gine oil. Damages caused by the use
of an oil not suitable for the engine or
by adding of an additives may not be
covered by the BRP Limited Warranty.
Engine Oil Level
NOTICE
Check level frequently
and refill if necessary. Do not over-
fill. Operating the engine with an
improper level may severely dam-
age engine.
CAUTION Many components
in the engine compartment may be
very hot. Direct contact may result
in skin burn.
Oil level can be checked with water-
craft either in or out of water.
If Watercraft is Out of the Water
NOTICE
Watercraft must be level.
CAUTION When operating the
engine out of water, the heat ex-
changer in the ride plate may be-
come very hot. Avoid any contact
with the ride plate as burns may oc-
cur.
1. Raise trailer tow pole, then block in
position when bumper rail is level.
2. Open the seat.
3. Install a garden hose on the exhaust
system flushing connector. Refer
to
EXHAUST SYSTEM in this sec-
tion and follow the procedure.
NOTICE
– Never run engine without supply-
ing water to the exhaust system.
Failure to cool exhaust system
may severely damage it.
– Never run engine longer than
2 minutes. Drive line seal has no
cooling when watercraft is out of
water.
4. With the engine already at normal
operating condition, let engine idle
for 30 seconds then stop engine.
126
______________
https://www.boat-manuals.com/