BRP SEA-DOO GTI 130 2019, Operator'S Manual

Page: 47 / 204

PRE-RIDE INSPECTION
NOTICE
The ski/wakeboard post is
designed for towing a skier or wake-
boarder with a maximum weight of
114 kg (250 lb).
Engine Cut-Off Switch and Engine
START/STOP Button
Press the start button once without in-
stalling the tether cord cap on the en-
gine cut-off switch.
Install the tether cord cap on the en-
gine cut-off switch.
Press the START/STOP button to start
the engine, then stop it by pressing the
START/STOP button a second time.
NOTE: To allow engine starting, the
tether cord cap must be properly in-
stalled on the engine cut-off switch
within 5 seconds of pressing the
START/STOP button.
Restart the engine, then stop it by re-
moving the tether cord from the engine
cut-off switch.
WARNING
Should the tether cord cap be
loose or fail to remain on the en-
gine cut-off switch, replace the
tether cord immediately in order
to avoid unsafe use. If remov-
ing the tether cord cap from the
engine cut-off switch or pressing
the START/STOP button does not
stop the engine, do not use the
watercraft. See your authorized
Sea-Doo dealer.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM OPERATION
✓
Information
Center
Check operation
Intelligent Brake
and Reverse
System (iBR)
Check operation
Variable Trim
System (VTS)
(as applicable)
Check operation
Information Center (Gauge)
1. Press START/STOP button and in-
stall the tether cord cap on the en-
gine cut-off switch.
2. As the information center cycles
through its self-test function, en-
sure all indications come on.
WARNING
Always attach the tether cord clip
to your PFD or to the wrist (wrist
strap required).
iBR System (if equipped)
NOTICE
Ensure there is sufficient
space ahead and behind watercraft
to safely carry out the iBR system
test to avoid a collision. Watercraft
will move during test.
1. Remove the moorings securing the
watercraft to the dock.
2. Start the engine and ensure the wa-
tercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the wa-
tercraft should move slowly back-
wards.
4. Release the iBR lever, there should
not be any reverse thrust.
WARNING
Always ensure proper iBR system
operation before taking the water-
craft out for a ride.
________
SAFETY INFORMATION
________
45
https://www.boat-manuals.com/