BRP Lynx Commander GT 1200 4-TEC Comfort, Operator'S Manual

Page: 68 / 164

CONTROLS, INSTRUMENTS AND EQUIPMENT
2. Insert the lower section of side
panel over the aluminium chassis
and the aluminium tab into the panel
slot.
mmo2009-004-047_a
1. Lower section
2. Aluminium chassis
3. Aluminium tab
4. Panel slot
3. Insert the panel dowel into the tun-
nel hole.
mmo2011-006-102_a
1. Dowel
2. Tunnel hole
4. Hook the rubber tie.
5. Lock the clip by turning it 1/4 turn
clockwise.
Lower Side Panel Removal/
Installation
1. Open lower side panel as explained
above.
2. Lift the front of side panel and free
the lower hinge from its slot.
3. Free the upper hinge by lowering
the panel.
Reverse procedure for installation.
30) Rewind Starter Handle
(If Applicable)
Auto-rewind type located on right hand
side of snowmobile behind side panel.
To engage mechanism, pull handle
slowly until a resistance is felt then pull
vigorously. Slowly release handle.
31) Spark Plug Storage
A space is provided in the tool kit to
keep spare spark plugs dry and pre-
vent shocks that might affect the ad-
justment or break them.
NOTE: Spare spark plugs are not sup-
plied with snowmobile.
NOTE: Check spare spark plug gap ac-
cording to
SPECIFICATIONS
before in-
stallation.
CAUTION Do not attempt to
adjust spark plug gap.
32) Fuel Tank Cap
Unscrew to fill up tank then fully
tighten.
WARNING
Always stop the engine before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity.
Open cap slowly. If a differen-
tial pressure condition is noticed
(whistling sound heard when loos-
ening fuel tank cap) have vehicle
inspected and/or repaired before
further operation. Do not overfill
or top off the fuel tank before plac-
ing the vehicle in a warm area. As
temperature increases, fuel ex-
pands and might overflow. Al-
ways wipe off any fuel spillage
from the vehicle. Periodically ver-
ify fuel system.
66
______________