BRP Lynx Commander GT 1200 4-TEC Comfort, Operator'S Manual

Page: 65 / 164

CONTROLS, INSTRUMENTS AND EQUIPMENT
NOTICE
Do not exceed maximum
load capacity of rear rack. MAXI-
MUM cargo load is 30 kg (66 lb).
26) Drive Belt Guard
Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE: Drive belt guard is purposely
made slightly oversize to maintain ten-
sion on its pins and retainers prevent-
ing undue noise and vibration. It is im-
portant that this tension be maintained
when reinstalling.
Remove the tether cord cap from en-
gine cut-off switch.
Refer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT and open engine
compartment LH side panel.
Remove retaining pin.
mmo2008-003-063_a
TYPICAL
1. Retaining pin
Lift rear portion of drive belt guard then
release from front tabs.
Drive Belt Guard Installation
When reinstalling drive belt guard,
position its cutaway toward front of
snowmobile.
Place belt guard front openings over
tabs.
mmo2009-004-035_a
1. Belt guard
2. Tabs
Position the grommet over the retain-
ing rod.
mmo2009-003-011_a
1. Retaining rod
Position rear portion of the belt guard
over the retainer and secure it using
the retaining pin.
mmo2008-003-063_a
1. Retaining pin
_______________
63