BRP Lynx Commander GT 1200 4-TEC Comfort, Operator'S Manual

Page: 117 / 164

MAINTENANCE PROCEDURES
Headlights Bulb Replacement
NOTICE
Never touch glass portion
of an halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
1. By using a small screwdriver, re-
lease multifunction gauge locking
tabs.
mmo2007-009-061_a
1. Locking tab
2. Gently pull on multifunction gauge
and set aside.
mmo2007-009-062_a
3. Unplug burnt bulb connector. Re-
move the rubber boot.
mmo2007-009-022_a
1. Rubber boots
4. Press and pull both sides of the re-
taining clip at the same time to re-
lease it from bulb support.
mmo2007-009-063_a
Step 1: Push both sides
Step 2: Pull to release
1. Retaining clip
5. Pull bulb and replace. Properly rein-
stall parts.
mmo2007-009-064_a
PULL BULB AND REPLACE
Headlights Beam Aiming
Remove multifunction gauge, refer to
HEADLIGHTS BULB REPLACEMENT .
Turn knob to adjust beam height.
______________
115