BRP Lynx Commander GT 1200 4-TEC Comfort, Operator'S Manual

Page: 105 / 164

MAINTENANCE PROCEDURES
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
5. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
mmo2010-009-001_a
1. Opening
2. Feeler gauge
6. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
7. Tighten screws to the specified
torque, following the illustrated se-
quence. Take care not to pinch the
feeler gauge.
mmo2010-009-007_b
TIGHTENING SEQUENCE
STOPPER SCREW TIGHTENING
TORQUE
10 N•m ± 2 N•m (89 lbf• in ± 18 lbf• in )
NOTICE
Serious pulley damage
can occur if the engine stopper and
its screws are not properly installed.
Brake Fluid
Recommended Fluid
Use only DOT 4 brake fluid from a
sealed container. An opened container
may be contaminated or may have ab-
sorbed moisture from the air.
______________
103