Brother HL-2700CN Series, Service Manual

Page: 210 / 377

VII-13
1) Open the paper exit unit.
2) Release the two lock knobs to remove the fuser unit from the printer.
Fig.7-8
3) Remove the setscrew (A) (BT3x6, 2 pieces) and pull up the two release levers to
remove the top fuser cover FU.
4) Remove the screw (B) to remove the lock knob KIT FU. (2 places)
5) Remove the setscrew (C) (BT3x8, 2 pieces) of the front fuser cover FU.
6) Remove the front fuser cover FU.
7) Remove the setscrew (D) (ST3x6, 1 piece and FU shoulder screw, 2 pieces) of the
bottom fuser cover FU.
8) Remove the setscrew (E) (SM3x6 with washer, 1 piece) from the bottom fuser cover
FU.
9) Remove the setscrew (F) (ST3x6, 1 piece) to remove the ground wire.
10) Remove the setscrew (G) (SM3x6 with washer, 1 piece) of the fuser lamp from the
terminal; Pull out the tube from the harness.
11) Remove the bottom fuser cover FU from the fuser roller assy FU.
12) Remove the setscrew (H) (SM3x6 with washer, 1 piece) of the fuser lamp terminal
from the terminal.
13) Remove the setscrew (I) (SM3x6 with washer, 2 pieces) of the lamp holder, and
then remove the lamp holder.
14) Pull out the fuser lamp from the fuser roller (HT).
Note:
Since the voltage of heater lamp is subject to the destination, confirm the specified
rated voltage. (US : 120V 940W, EC : 240V 940W, JP : 100V 940W)
15) Remove the setscrew (J) (ST3x6 with washer, 2 pieces) to remove the two
terminals of the fuser connector harness.
16) Disconnect the connector connecting to the fuser connector FU.
17) Remove the FU shoulder screws (K) (2 pieces) to remove the fuser connector FU
from the bottom fuser cover FU.
18) Remove the setscrew (L) (BT3x6, 1 piece and BT3x12, 1 piece) to remove the
thermistor assy FU from the bottom fuser cover FU.
Fuser unit
Lock knob
Lock knob
Paper exit unit