Brother HL-2700CN Series, Service Manual

Page: 243 / 377

VII-46
4.46 Paper Exit Unit
1) Open the paper exit unit.
2) Remove the setscrew (BT4x20, 1 piece and collar) from the support band.
3) Remove the setscrew (ST4x6, 1 piece) from the support plate. In this instance,
maintain the paper exit unit closed.
4) Open the paper exit unit and pull its right side to the backside, so that the hinge shaft
can be removed from the right-side base assy.
5) Slide the paper exit unit to the right side, to release the hinge shaft from the frame.
6) Pull the paper exit unit to the backside, and then remove it.
CAUTION
When pulling the rear cover Assy PU, make it slowly by releasing the tension of the rear
unit support. Be careful about the abrupt return of the rear unit support due to the
reaction of the spring.
Fig.7-54
Support plate
Paper exit unit
Hinge shaft
ST4x6
Right-side base assy
Support band
BT4x20 Collar