-17-
Setup
GLASS FRAME ASSEMBLY
REMOVE GLASS FRAME ASSEMBLY
1. Remove the two #8 X 0.375 screws that secure the control cover tray to the unit. Once the two #8 screws are
removed lift the control cover unit up and out of the unit.
Log and liner Installation
• If converting to LP (propane) gas, complete the conversion before installing the log set. Follow the conversion
instructions included with the kit.
• Refer to the instruction sheets provided with your log and liner set for proper installation.
Only log and liner sets certified with the appliance shall be used. NOTE: This fireplace should not be burned
without the approved logs, surrounds, and liners properly installed. Use without the logs, surrounds, and liners
properly installed could cause damage to the appliance.
Certified Log/Media
Certified Liner Sets
WARNING: Do not remove the glass assembly when hot.
WARNING: Use only authorized parts and materials when replacing defective or damaged glass.
WARNING: Do not operate with the glass removed, cracked, or broken. Replacement of the glass assembly
should be done by a licensed or qualified service person.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame
appearance and cause excessive soot to build upon the logs and glass.
2. Locate (2) spring-loaded latches securing the glass assembly at the top of the glass frame.
Summary of Contents for BH6113LFP
Page 34: ...34 Notes...
