BRAYER BR2701, Instruction Manual, Page: 22 / 104

22 EN
Table of malfunctions and defects during bread baking and recommendations on
further troubleshooting.
Malfunction/Defect Possible reason Troubleshooting method
Smoke from the openings
in the lid during bread
baking
During the first use of the bread maker, the
surface of the heating element burns.
Getting of ingredients on the heating
element.
Before the first use of the bread maker, switch it on for
10-15 minutes with the open lid.
Switch the bread maker off, allow its cooling, clean the
heating element.
Thick bread crust.
The ready bread was left in the baking
form and lost a lot of moisture.
Remove the ready bread from the form, right after
baking.
The kneading paddle can
not be removed from the
baking form.
Dough has got in the gap between the
driving shaft and the dough kneading
paddle.
After you have removed bread from the form, fill the
baking form with warm water. Remove the paddle in
20-30 minutes.
Ingredients are mixed
unevenly and are baked
poorly.
The preset program does not suit for this
set of ingredients.
During the baking program operation the
bread maker lid opened several times, the
dough dropped and did not rise any more.
Small quantity of liquid ingredients, the
kneading paddle is not capable to knead
dough for pastry.
Select the baking program that corresponds to the
ingredients loaded in the baking form.
Do not open the bread maker lid.
Check the conformity of loaded ingredients.
Remove the baking form and try to rotate the baking
paddle with your hand, if it does not work, contact the
authorized service center.
If the symbols «LLL» are
shown on the display when
you switch the bread maker
on.
The temperature inside the bread maker
is too low.
Switch the bread maker off and unplug it. Open the
bread maker lid, remove the baking form and let the unit
heat up to the room temperature for 10 — 20 minutes.
If the symbols « EE0» are
shown on the display when
you switch the bread maker
on.
Malfunctioning
Switch the bread maker off and unplug it. Wait for some
time and then switch the bread maker on again. If the
symbols «EE0» still glow, apply to the authorized service
center.