Branson 3015h, Owner'S Manual

Page: 125 / 454

2
-
79 42hw-201601
Chapter 2 enGIne 3015r(h)/3515r(h)/4015r(h)/F36r(h)/F42r(h) traCtOr
2
6.3.4 pIStOn & pIStOn rInG
If the main measurement value is over the limit,
replace the pistons
If there is any damage or scratch on the surface,
replace it
Piston outer diameter
•
•
•
Item SpeCIFICatIOn LImIt
Piston outer
diameter
87.95.~.87.97 87.90
Minimum
clearance .
with cylinder
0.060.~.0.080 -
When replacing the piston ring, make the ring
groove clean. And assemble it toward top of the
piston to be saw the mark on top and make sure
it moves well.
When the piston ring assemble, ring’s cut
direction shouldn’t be in side-pressured area and
make it cross each other by 120 degree.
Measure each main area and replace it if it is over
limit.
Measure the piston ring clearance
•
•
•
•
Item SpeCIFICatIOn LImIt
First Ring 0.25~0.40 1.5
Second Ring 0.50~0.70 1.5
Oil Ring 0.20~0.40 1.5
(mm)
ᶟ⪿㈯#ཌ⫃⃋ཋ#㢇◯㓯#
␌ὴ㣰⪇ᮧ#㣰㢣ᜏᮨ#⮻ᴈ
\
K20W268A
ᴌ#ླྀ
㢇◯㓯#ᴌ
53#pp
☯᳻᚟#⅟ᮨ
K20W269A
Ring gap
Piston ring
Cylinder block
The side with manufacturer's .
mark shall face upward.
CheCk the pIStOn
pIStOn Outer dIameter
▶
pIStOn rInG
▶
(mm)