bpr Rotax 912 i Series, Maintenance Manual, Page: 68 / 458

Effectivity: 912 i Series
Edition 1/Rev. 1
d0
561
9.
fm
MAINTENANCE MANUAL
BRP-Powertrain
24-20-00
Page 18
October 01/2013
Fig. 37
Fig. 38
Fig. 39
1. Ignition housing
Step Procedure
4 Install ignition housing on the crankcase
with puller assy. part no. 876010.
1. Ignition housing
m
WARNUNG
m
WARNING
Danger of injury!
The magnet of the fly wheel pulls the ignition
cover towards the engine/sealing surface with
great force.
Fingers can be crushed.
Step Procedure
5 Turn the water pump wheel slightly so that
the gear wheels can mesh.
6 Fasten the ignition housing to the crank-
case using Allen screws.
Tightening torque 10 Nm (88.48 in. lb.)
m
WARNUNG
NOTICE
The ignition housing must be attached manually
without tapping.
Ignition housing screw diagram
1. M6x30 Allen screws 2. M6x50 Allen screws
3. Ignition housing assy.
Step Procedure
7 Secure M6x50 Allen screw with LOCTITE
243 and tighten it.
Tightening torque 10 Nm (88.48 in. lb.)
m
WARNUNG
NOTICE
Do not use a longer screw!
The screw would press on the cylinder shroud
and cause damage to piston and cylinder.