159
8. Using a #2 Phillips screwdriver, remove the 5 indicated screws
(by ovals) from each of the Rear Middle Pulley Shrouds. Place them
outside the work area.
9. Using a #2 Phillips screwdriver, remove the two indicated screws
(by arrows) from the Upper Rear Shroud.
10. Remove the Upper Rear Shroud and place out of the work area.
11. Safely remove the Middle Hand Grip and the Snap Hook from the
Middle Pulley Arm.
12. Slowly pull out enough of the Middle Rope to be able to remove
the Securing Ball from it.
The Rope will be under tension and will want to pull itself
into the Middle Pulley Shroud. Be sure not to allow
fingers or hands to be pinched.
13. While keeping the rope from retracting, remove the Securing Ball
from the rope. Do not release the rope until instructed.
Note:
Be sure to observe how the rope routes through the Middle
Pulley to assist with re-assembly. To remove the Securing Ball: Slide
the Securing Ball up the rope, remove the Center Stopper from the
rope, and slide the Securing Ball off the rope.
Middle Hand Grip
Securing Ball
Securing Ball
Center Stopper
Upper Rear Shroud
Rear Middle Pulley
Shroud
