HD Conference Dome
Using the IP Interface | en
65
Bosch Security Systems, Inc.
Installation Manual
F.01U.265.806 | 1.0 | 2012.03
11.4
Configuring the HD Conference Dome
Camera
To operate the camera in your network you must assign it a
valid network IP address. The default IP address is 192.168.0.1,
but you may have to change this address if it conflicts with
another device on your network. Refer to
Section 12.3 Basic
Mode: Network, page 83
for more information.
To properly configure the camera for your network, you need
the following information:
–
Unit IP address: An identifier for the camera on a TCP/IP
network. For example, 140.10.2.110 is a valid syntax for an
IP address.
–
Subnet mask: A mask used to determine what subnet an IP
address belongs to.
–
Gateway IP address: A node on a network that serves as an
entrance to another network.
–
Port: An endpoint to a logical connection in TCP/IP and
UDP networks. The port number identifies the use of the
port for use through a firewall connection.
NOTICE!
You can also use the Bosch Configuration Manager utility to
configure the network settings for an HD Conference Dome. Go
to www.boschsecurity.com to download the Configuration
Manager software and Operating Manual.
NOTICE!
Ensure that the network parameters of your cameras are
available before you begin configuration.