"Additive value entry" can be used to enter D-correction values that are to be
added to the existing value (see section
chapter "Value Entry" on page 96
).
7.4.5
Placements
General Information on Placements
The placement editor is used to display and enter offset values (X, Y, Z) and
turning angles (phi, theta, psi). A comment with a maximum of 32 characters
can be assigned to each correction value.
Fig.7-17:
Placement editor
A placement table can contain a maximum of 5 correction pages, each of which
contains offset values G154.x to G159.x.
The unit of a placement table can be determined on the basis of the column
headers of X, Y and Z ([mm] or [inch]). Turning angles phi, theta and psi have
a unit of [°].
The unit of a placement table is already determined from parameter
9020 00010 of the configuration data during the creation of the table
and is stored with the table.
The number of decimal positions displayed is specified by parameters 6020
00021 and 6020 00022 in the configuration data.
Operating the Placement Editor
General Information
Only the functions affecting the placement editor are described here. The gen‐
eral operation of table editors is described in
chapter 7.4.2 "Operation" on page
Functional Keys in the Placement Editor
The following table shows all functional keys of the placement editor:
Application Description | Rexroth IndraMotion MTX 09VRS
Electric Drives
and Controls
| Bosch Rexroth AG 107/233
Programming
Additive Value Entry
Number of Correction Pages
Unit of the Table (mm/inch)
Number of Decimal Positions
