20/84 Installation
Bosch Rexroth AG
, MIT: ID 200, 3 842 540 399/2016-11
5.3 Installation
The rotary switch for setting the device address is located on the bottom of the
ID 200/C-PDP. Once the ID 200/C-PDP has been mounted, these rotary switches
are no longer freely accessible.
Set these rotary switches before mounting the ID 200/C-PDP (see section 6.4
“Address setting” .
5.4 Connection
The electrical connection via plug-in connectors enables simple installation.
5.4.1
Power supply
The power supply is connected via a M12 plug-in connector with integrated voltage and
inverse-polarity protection indicator (green: correct polarity, red: incorrect polarity).
There is also a connector on the housing with the following pin assignment:
Fig. 13:
4
1
3
2
Power supply pin assignment
For suitable connection cables, refer to section 4.2.2 “Cable sockets for the
energy supply” .
5.4.2
Antennas and trigger sensors
You can connect up to two antennas (125 kHz or 13.56 MHz) to the ID 200/C-PDP.
You can also connect a trigger sensor to socket 1 or 2 in place of one antenna. You can
assign an antenna to the trigger sensor. The trigger sensor must be positive switching.
Fig. 14:
D
Signal
E
F
C
2
1
3
4
5
+
A
–
+
–
B
1
2
3
4
5
Antenna and trigger sensor pin assignment
For suitable antennas, refer to section 4.1.1 “Antennas” .
For suitable connection cables, refer to section 4.2.1 “Communication module
connection cable to antennas and trigger sensors” .
1:
+ 24 V
2:
NC
3:
GND
4:
NC
C:
Housing socket
D:
Antenna
E:
Trigger sensor
F:
Trigger switch
