FPD-7024
|
Operation and Installation Guide | 5.0
Control Panel Programming
.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03
59
Table 22: Phone Number Control Characters
Press See
Action
[TEST] 1
*
Touch Tone “*”
[TEST] 2
#
Touch Tone “#”
[TEST] 3
/
Three-second delay
[TEST] 4
>
Wait for dial tone
Several keys assist when you enter phone or IP numbers (refer to
Table 23
on page 59).
Table 23: Phone Number Assistance Keys
Press Action
[SILENCE]
Advance to next position
[DISABLE]
Go back one position
[RESET]
Clear position
If the wait for dial tone is not specified, the control panel waits 7 sec after going off-hook, and then
dials whether or not the dial tone is present.
For a phone number, you must enter
1
as a prefix before the special character
>
. Except for
unusual situations, all phone numbers should have the wait for dial tone character as the second
digit. This ensures that reports are delivered as quickly as possible, even if an incoming phone call
must be disconnected. For example, you would program
1>18002890096
for the phone number
1-800-289-0096.
To enter a central station IP address in either phone number 1 or 2 in the control panel, replace all three
phone numbers with an IP address. To distinguish an IP address from a phone number, enter 0 as the first
digit, followed by the 12 digit IP address.
The IP address must be 12 digits long.
For example, if the IP address is 172.30.1.101, the phone number is programmed as 0 172 030
001 101. Do not add the spaces. They are included for readability.