Bosch CIP-5316-JBOD, User Manual

Page: 21 / 68

CIP5000 series storage Hardware configuration | en 21
Bosch Security Systems B.V. User manual 2019-10 | V01 | F.01U.380.030
Rails installed
and tightened
Brackets
3U 16-bay
enclosure hardware
Figure 5.3: Placing the enclosure hardware onto the rack rails
Screws and flange
nuts attach the
enclosure hardware
to the rack posts
Figure 5.4: Secure to rack
Handles mount
outside the rack post
Mounting rails mount
outside the rack post
Vertical rack post
Figure 5.5: System installed in rack
To install the enclosure hardware into a rack with the supplied rails:
1.
Check the fit of the rails in your rack system.
2. Adjust the length of the rails as needed.
–
The rear half of the rail slides inside the front half. The rail halves are riveted
together, so no adjustment screws are needed.
– The front-left and front-right rail ends are labeled.
– Be sure the front rail support is on the bottom facing inward.
– All rail ends, front and rear, attach at the outside of the rack posts.
– The guide pins at the rail ends align with the holes in the rack posts.