Bosch CIP-5316-JBOD, User Manual

Page: 24 / 68

24 en | Hardware configuration CIP5000 series storage
2019-10 | V01 | F.01U.380.030 User manual Bosch Security Systems B.V.
!
Caution!
The CIP5000 models support hot-swapping disk drives.
To avoid hand contact with an electrical hazard, remove only one drive carrier at a time.
Push here when returning
or replacing the carrier into
an empty drive bay.
Pull here to release the carrier handle latch.
Then pull the carrier straight out by the handle.
Place your free hand under the carrier.
Do not drop the disk carrier, even if it is empty.
Figure 5.9: Disk carrier with HDD installed (front view)
5.3.3 Install 3.5" disk drive in the carrier
Obey the following instructions to install 3.5” hard disk drives into the drive carriers.
1.
Remove a disk drive carrier.
2. Carefully lay the disk drive into the drive carrier at the front, so that the screw holes on
the sides line up correctly with the power and data connectors facing away from the
carrier handle.
3. Insert the screws through the holes in the drive carrier and into the sides of the disk
drive.
–
Install only the counter-sink screws supplied with the drive.
– Install four screws per drive.
– Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the enclosure.
Repeat steps 1 through 3 until all of your disk drives are installed.