Section 03
ENGINE
Subsection 07
(LUBRICATION SYSTEM)
VMR2004_011_03_07A.FM
03-07-7
Measure oil pump rotor thickness and oil pump
rotor bore depth.
Difference between measurements should not
exceed 0.25 mm (0.009 in). If so, replace oil pump
rotor.
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Markings on inner rotor and oil pump rotor must
be visible.
Coat inner rotor and oil pump rotor with oil.
PRESSURE OIL PUMP
The pressure oil pump
no. 26
is located near the
return oil pump.
1. Pressure oil pump gear
For removal, inspection and installation, use the
same procedures that return oil pump.
ENGINE OIL STRAINER
The engine oil strainer
no. 27
is located between
both crankcase housings.
Removal
Separate both crankcase housings. Refer to
CRANKSHAFT/BALANCER SHAFT section.
Unscrew the bolts
no. 28
retaining the oil strainer
guide
no. 29
.
Cleaning and Inspection
Clean engine oil strainer with a parts cleaner then
use an air gun to dry it.
Check engine oil strainer for damage and change
if necessary.
Installation
For installation, reverse the removal procedure.
OIL PUMP ROTOR AND INNER ROTOR
CLEARANCE
SERVICE LIMIT
A
0.25 mm (0.009 in)
B
C
V02C42A
1
V02C3ZB
Summary of Contents for DS 650
Page 1: ......
Page 2: ...Shop Manual 2004 DS 650TM DS 650TM BAJA DS 650TM BAJA X ...
