Section 02
MAINTENANCE
Subsection 03
(MAINTENANCE/LUBRICATION)
02-03-6
VMR2004_004_02_03A.FM
Remove:
– the screws retaining the spark arrester to the
muffler
1. Screws
2. Spark arrester
– spark arrester and sealant joint
1. Spark arrester
2. Sealant joint
3. Muffler
– inner grill with wool.
Remove all carbon deposit in the muffler.
Remove carbon deposits from the spark arrester
using a brush.
NOTE:
Use a soft brush and be careful to avoid
damaging spark arrester.
Installation
For installation, reverse the removal procedure, pay-
ing attention to the following details:
Check:
– wool and change if it deteriorate
– the spark arrester condition, it must be free of
breaks and holes. Replace if necessary.
Remove the old sealant joint and replace by a new
one. Use ULTRA COOPER sealant (P/N 293 800 090).
Be sure that insulating material is in place when
inserting grill.
Align grill properly in bottom of muffler shell.
TIRES AND WHEELS
Tire Pressure
Check pressure when tires are cold before using
the vehicle.
1
1
2
V02C06A
1
3
V02C07A
2
WARNING
When the tires are replaced, never install a
bias tire with a radial tire. This combined ap-
plication may create handling and/or stability
problems.
Do not mix tires of different size and/or design
on the same axle.
Front tire pairs or rear tire pairs must be the
identical model and manufacturer.
For unidirectional tread pattern, ensure that
the tires are installed in the correct direction
of rotation.
The radial tires must be installed as a com-
plete set.
Severe injury or death can result if you do not
follow these instructions.
WARNING
Tire pressure greatly affects vehicle handling
and stability. Under pressure may cause tire
to deflate and rotate on wheel. Overpressure
may burst the tire. Always follow recommended
pressure. Since tires are low-pressure types, a
manual pump should be used.
V02C08A
Summary of Contents for DS 650
Page 1: ......
Page 2: ...Shop Manual 2004 DS 650TM DS 650TM BAJA DS 650TM BAJA X ...
