Section 03
ENGINE
Subsection 07
(LUBRICATION SYSTEM)
03-07-4
VMR2004_011_03_07A.FM
Drain all oil from oil tank
no. 5
by removing oil tank
drain plug
no. 6
. Wipe out any oil spillage.
1. Oil tank drain plug
2. Oil tank strainer
Place a drain pan under the engine drain plug area.
Unscrew engine drain plug
no. 7
.
UNDER VEHICLE
1. Oil drain plug
Wait a while to allow oil to flow out of oil filter.
Unscrew oil filter cover
no. 8
.
Remove oil filter and replace by a new.
NOTE:
Check and change O-ring
no. 9
, if neces-
sary.
TYPICAL — RH SIDE OF VEHICLE
1. Oil filter cover
2. Oil filter
3. O-ring
Wipe out any oil spillage on engine.
Change gasket
no. 10
on engine drain plug. Clean
gasket area on engine and drain plug then reinstall
plug. Refill oil tank at the proper level with the
recommended oil. Refer to TECHNICAL DATA
for capacity.
Start engine and let idle for a few minutes. Ensure
oil filter area, hoses and drain plug areas are not
leaking.
Check if the RED indicator lamp stays ON, if so,
stop engine and bleed system by removing oil
filter and bleeding screw
no. 11
. Refer to BLEED-
ING ENGINE OIL CIRCUIT below.
If the RED indicator light turns OFF, the system is
good.
Stop engine and recheck oil level. Refill as neces-
sary.
Dispose oil as per your local environmental regu-
lations.
1
V02C3YA
2
1
V02C4XA
2
1
3
V02C04A
Summary of Contents for DS 650
Page 1: ......
Page 2: ...Shop Manual 2004 DS 650TM DS 650TM BAJA DS 650TM BAJA X ...
