Section 08
SUSPENSION
Subsection 03
(REAR SUSPENSION)
08-03-2
VMR2004_027_08_03A.FM
GENERAL
CAUTION:
The Baja and Baja X models are
equipped with shocks absorber protectors.
Open or remove them if the vehicle is used in-
tensively or if the ambient temperature is high.
Otherwise, shock absorber performance deg-
radation or damage can occur.
For installation, use the torque values and Loctite
products from the exploded views. Clean threads
before using Loctite when installing the screws.
SHOCK ABSORBER ASS’Y
Removal
Lift rear of vehicle until rear shock absorber
no. 1
is fully extended.
Install a jack stand or a block under the frame to
support the vehicle.
Unscrew clamps
no. 3
retaining the reservoir
no. 4
.
Remove upper bolt
no. 5
retaining shock absorber.
Remove brake caliper and move aside. Unlock
disc brake hub and slide it aside to gain access to
lower bolt of shock absorber. Loosen chain and
remove rear sprocket. Refer to REAR AXLE.
Remove LH and RH access plugs of shock absorb-
er lower bolt.
1. LH plug removed to access shock absorber bolt
Unscrew the lower bolt
no. 6
.
TYPICAL
1. Upper bolt and nut
2. Lower bolt and nut
3. Reservoir
4. Clamps
5. Brake caliper
6. Disc brake hub
WARNING
Torque wrench tightening specifications
must strictly be adhered to.
Locking devices (ex.: locking tabs, elastic stop
nuts, self-locking fasteners, etc.) must be in-
stalled or replaced with new ones where
specified. If the efficiency of a locking device
is impaired, it must be renewed.
1
V02J0RA
3
1
V02J0VA
4
5
6
2
Summary of Contents for DS 650
Page 1: ......
Page 2: ...Shop Manual 2004 DS 650TM DS 650TM BAJA DS 650TM BAJA X ...
