Bomar SV 330 DGH, Operating Instructions Manual

Page: 53 / 113

53
Ú
d
rž
b
a
s
tr
o
je
W
a
rtu
n
g
M
a
c
h
in
e
s
e
rv
ic
e
2. Set the brush to the saw band. Ends of the brush bristles should not touch
the base of the saw band teeth (see picture below).
3. Tighten the bolt again and switch on the saw band drive. If the brush is
adjusted properly, it runs fluently together with the saw band.
4.4.6. Adjusting the limit switch of the saw band stretching
After the saw band is replaced, the limit switch setting must be checked. If the
limit switch is not set correctly, the band is stretched either too much or too
little.
1. Stretch the band with help of the TENZOMAT to an optimal value
(Tenzomat chart)
2. Release the nut on the stop screw
3. Start the band drive. Two scenarios may occur:
•
If the engine is switched on, but it does not run, turn the screw to the
left until the engine starts running
•
If the engine runs turn the screw to the right until it stops, then turn the
screw shortly to the left until the engine starts running again
Fasten the stop screw with the nut and check the setting of the switch again.
Attention!
The brush must not touch the bottom of the saw teeth!