Bomar SV 330 DGH, Operating Instructions Manual

Page: 10 / 113

10 Manual version: 2.00/May 2016
Manual rev.: 2
B
e
z
p
e
č
n
o
s
tn
í
p
o
k
y
n
y
S
ic
h
e
rh
e
it
s
h
in
w
e
is
e
S
a
fe
ty
n
o
te
s
Operate the machine only when you are fit enough for work. Illnesses or
injuries diminish concentration.
Avoid machine work, which may jeopardize the safety of you and your
colleagues!
1.3. Safety instructions for machine operator
Machine can only be operated only by one person at a time. Machine operator
is responsible for other people present near the machine.
The person who is operating the machine using the control elements (control
panel and other) must not either alone or with help of other workers move the
cut or otherwise machined material at the same time.
Close covers before starting the machine and check, if the covers are not
damaged. Damaged covers must be repaired or replaced immediately. Do not
start the machine, if any cover is removed!
Check, if the electric cables are not damaged.
Do not hold or manipulate the material during clamping or cutting!
Do not operate the buttons and switches on the control panel wearing gloves!
You may press a wrong button.
Make sure, that there is nobody in the working area of the machine (the
working area of the vice, the saw band, the saw arm etc.) during a working
cycle and when starting the machine.
Under no circumstances touch any rotating elements.
Use the machine only when it is in a good condition!
Check at least once in a shift, if the machine is not visibly damaged. If you
discover any such damage, you must bring the machine to a halt and inform
your superior!
Keep your working area and machine clean and uncluttered! Ensure sufficient
lighting in the working area.
Take off any spilt water or oil from the floor and dry it immediately to avoid a
possibility of injury.
Do not touch the cooling liquid with bare hands!
Do not adjust the cooling liquid nozzle if the machine is running.
Do not remove the chips from the working area of the machine, when the
machine is running!
Do not use compressed air for machine cleaning or for chip removal!
Use protective gear for chip removal
Attention!
Do not connect the machine to electricity if the door or any
covers are removed. Do not touch the high voltage
electrical equipment (transformers, motors, terminals or
Follow the instructions and directives for work safety!
Read the operating instructions before you start to
work on the machine! Keep the operating instructions
in good condition!
Attention!
Machine can only be operated by a person older than
18 years!
Machine can be operated only by a person physically
and mentally fit for this activity.