Bomar SV 330 DGH, Operating Instructions Manual

Page: 23 / 113

23
D
o
k
u
m
e
n
ta
c
e
s
tr
o
je
D
o
k
u
m
e
n
ta
tio
n
d
e
r M
a
s
c
h
in
e
n
M
a
c
h
in
e
d
o
c
u
m
e
n
ta
tio
n
2.4. Transportation and stocking
2.4.1. Conditions for transportation and stocking
Follow the recommendations of the manufacturer for transportation and
stocking! If the recommendations are not kept, damage may occur to the
machine.
•
Don’t use a forklift truck for handling the machine, if you do not
have a license for it!
•
Don’t move under suspended loads! Fault in the lifting device may cause a
serious injury.
•
Keep a safe distance from the machine during transport.
•
Temperature of the air must be between -25°C and 55°C, for a short period
(max. 24 hours) up to 70°C.
•
Do not expose the machine to radiation (microwave radiation, ultraviolet
radiation, laser radiation, x-ray radiation). Radiation can cause problems
with the machine function and deteriorating of the condition of the
insulation.
•
Take measures, to prevent damage by dampness, by vibrations and by
shakes.
2.4.2. Transport and stocking preparations
•
Tighten the vice and thoroughly oil all smooth surfaces.
•
Lower the saw frame to the lowest position.
•
Make sure to empty the machine of all traces of cooling agent.
•
Fasten all loose parts securely to the machine.
•
Pack and wrap the control panel securely to avoid damage during
transport.
•
Put stickers stating the minimum approximate machine weight to at least
five well visible places.
The machine has to be screwed to a pallet for transportation. Make sure the
pallet is firm enough to be able to hold the saw.
2.4.3. Transport and stocking
Handle the machine only with the hand pallet truck or the forklift truck! Use the
lifters of the truck according to the Transport schema
Make sure that the hand pallet truck or forklift truck has sufficient lifting
capacity.
Make sure that the van or the trailer had sufficient capacity
The machine must be secured sufficiently during transportation so it won’t roll
over or fall off the vehicle.
Fasten the pallet to the floor of the vehicle.
Beware of damaging the machine during transportation.
It is forbidden to handle the machine in any way different from that written in
these operating instructions (for example lifting it by the saw arm); the machine
could get damaged!
Store the machine only under conditions mentioned in the manual to avoid
damaging it.