Bomar SV 330 DGH, Operating Instructions Manual

Page: 48 / 113

48
Manual version: 2.00/May 2016
Manual rev.: 2
Ú
d
rž
b
a
s
tr
o
je
W
a
rt
u
n
g
M
a
c
h
in
e
s
e
rv
ic
e
4.2. Saw band installation
1. Prior to installation, clean the track wheels, guiding cubes and inner side
of the arm thoroughly of all traces of chips and dirt. Keep in mind the
teeth direction when installing the saw band.
2. Insert the new saw band in the guide cubes. Make sure the saw band runs
between both guiding rollers and that it is pushed all the way to the top.
3. Insert the new saw band inside the protective cover of the arm.
4. Mount the saw band on both guiding wheels. Make sure that the saw band
ridge fits tightly to the wheel rim. Push the saw band as tightly to the rim
as possible.
5. By turning the stretching star to anticlockwise (tighten), stretch the saw
band slightly. Turn the stretching star anticlockwise (tighten) till you
activate the limit switch. For correct stretching of the saw band make an
additional ¼ of a turn in the same direction. Now you can remove the
plastic cover on the saw band.
6. Install the yellow protective cover of the band. The arrow on the cover
must match the direction of the teeth (see picture). If it does not, you must
flip the band.
7. Remove the plastic cover of the saw band teeth, adjust the brush to the
band and install the rear protective cover of the arm.
8. Adjust the hard metal guides.