Bomar SV 330 DGH, Operating Instructions Manual

Page: 44 / 113

44
Manual version: 2.00/May 2016
Manual rev.: 2
O
v
lá
d
á
n
í
s
tr
o
je
B
e
d
ie
n
u
n
g
d
e
r
M
a
s
c
h
in
e
M
a
c
h
in
e
c
o
n
tr
o
l
3.5. Material insertion
Never walk under a suspended load!
Never climb onto the-roller conveyor!
Do not hold the material for clamping in the vice! The vice can cause injuries!
3.5.1. Handling agent selection
Use the sufficient means to lift and transfer the material!
Handle the material only with a lift truck or use suspension strands and a
crane!
Do not use the lift truck or crane in case that you do not have the license to
operate it!
3.5.2. Insertion
Insert material into the vice and ensure that the material cannot move in the
vice or fall from the vice after the clamping. If you are cutting long pieces (for
example rods, tubes), you must use a roller conveyor for shifting the material
to the band saw. Contact Bomar for more information about roller conveyors.
Make sure the conveyor is long enough and the material cannot drop off the
conveyor.
Make sure round pieces always stay on two vertical rollers and cannot
fall off the conveyor!
3.5.3. Bundle material cutting
If you want to cut bundled material, there are some procedures for handling
the bundles.
Round material bundle: Take care (especially with round material) that the
bars are put according to the picture. If the bars are put differently, you may
have problems moving them.
Weld the material at the rear end of the bundle to secure it.
Before welding always switch off the machine with the main switch! Magnetic
fields which often occur during welding may damage the control systems!
Attention:
Not all shapes are suitable for cutting in a bundle.
Follow the recommendation of your saw band supplier
for material insertion in a bundle.