S2000M MAINTENANCE
GUIDE
7
addresses of devices and address expanders, set, change and remove user passwords, change own
password, setup and change console configuration for work with the partitions and relay outputs
at personal computer using program ‘
pprog.exe
’ ver.
2.04
. This password has no device and
partition control rights! Engineer password can has from 1 up 8 digits. Default value is -
<123456>. Change it before starting device operation! Console allows reset the password in
default value if it was forgotten.
User passwords can have numbers from 2 to 2047 and designed for arming/disarming
control. PIN - codes, and Touch Memory keys and Proximity cards can be used as password. PIN
– code is digit code, input from the keyboard. Maximal PIN default length is 4 digits, but can be
changed in range from 1 to 8 digits. Touch Memory key and Proximity cards control is made by
readers, connected to the ‘S2000-4’, ‘S2000-2’, ‘Signal-20P SMD’ and ‘S2000-KDL’ devices.
Each user password has access level. According to level password can have partition
control rights or device control rights.
Access levels for partition control are determined accessible partitions and permitted for
control actions (partition arming/disarming). It can be set up to 252 access levels (numbers from 1 to
252). Partition control rights are described in the item.
Note – Access level can have control rights for any partition number (up to 511) and
partition groups (up to 128), but up to 8 access levels can have one partition or group.
Console has three default access levels for device control: ‘ARM and DISARM’, ‘ARM
w/o DISARM’, ‘MAX AUTHORITY’. Access level ‘ARM w/o DISARM’ gives the right for
alarm loop individual or group arming, and also alarm reset and alarm loop state request. Access
level ‘ARM and DISARM’ gives also the right for alarm loop individual or group arming and
disarming. Access level ‘MAX AUTHORITY’ has all control functions rights. Comparing with
the level ‘ARM and DISARM’ there are accessible general arming and disarming, manual
device output control, printing buffer events, setting time and data, request ADC. Device control
functions are described in item.
Note – Access to the control functions is protected by passwords, if option ‘CODE
REQUIRED’ is on. If option ‘CODE REQUIRED’ is off loop control functions are accessible
without password.
By default console has one user password, with number 2, it has value <1234> and access
level ‘MAX AUTHORITY’.
Console allows setup password owner to add, remove and change user passwords. Users
can change own password by console.
1.2.19
States of LED indicator ‘READY’ (green) in different modes of work through
interface RS-232 are shown in the table 1.
1.2.20
Console provides states indication of all system partitions on LED indicators
‘ALARM’, ‘FIRE’, ‘TROUBLE’ and ‘FAULT’ according to tables 2 - 5. Indicator’s colour is
red.
1.2.21
Console sound signals are shown in the table 6.
Table 1
Indicator ‘READY’ (green)
Mode State
Indication
Work with printer
Any
On
Norm On
Work with computer
No connection with computer through RS-232
Blinks with frequency 1 Hz
Computer does not poll devices
Off
Programming mode,
Mode PI
Computer polls devices
On, if computer sends data to the
device, else off
