BlueTree BT-2000, Product Manual

Page: 12 / 74

Introduction
12 BlueTree Wireless BT-2010 Product Manual V1.5
• Configure basic operating parameters
• Establish packet data connections
• Monitor status information
The modem is equipped with a Trimble Lassen™ SQ GPS (Global
Positioning System) receiver. The receiver's GPS information is
available to host computers via a serial port.
Host computers can communicate with the GPS receiver using one of
the following data protocols via the AUX serial port.
What you will need
Before you install the modem you will need the following:
Cellular antenna
To comply to FCC and Industry Canada regulations, cellular antennas
must meet the following specifications:
•
Rated gain of 3dB (5.15dBi)
• Minimal cable loss of 0.5dB
• Dual-band 800 & 1900 MHz
• Nominal 50 ohm impedance
• Male TNC connector
• Coil style cellular whip
• Mount designed for a horizontal metal surface of vehicle
Protocol Description
TSIP Trimble Standard Interface Protocol
- Binary, bidirectional
- Default protocol of GPS receiver
TAIP Trimble ASCII Interface Protocol·
- Uses printable character based “sentences”
NMEA 0183 National Marine Electronics Association Protocol
- ASCII character based
- Unidirectional (from receiver only)
Warning : Antenna must not exceed 5.15 dBi. This
device must be used in mobile configurations. The
antenna(s) used for this transmitter must be
installed to provide a separation distance of at least
30cm or 12 inches from all persons and must not be
co-located or operated in conjunction with any other
antenna or transmitter. Users and installers must be
provided with antenna installation instruction and
transmitter operating conditions for satisfying RF
exposure compliance.
Warning : Only approved antennas may be
connected to the modem. Unauthorized antennas,
modifications, or attachments could impair data
quality, damage the modem, or result in the
violation of FCC regulations.