BlueTree BT-2000, Product Manual

Page: 47 / 74

Appendix B: Reference Information
V1.5 BlueTree Wireless BT-2010 Product Manual 47
change your modem settings by accessing the BlueVue Control Panel
applet.
To configure BlueVue and your modem:
1.
Click Start > Settings > Control Panel.
2.
Double-click BlueTree Wireless Data .
3.
On the BlueTree Modem Properties box click the Settings tab. You
can now modify the modem settings.
Service Control
BlueVue is composed of two components: a graphical application or
Client and a service or Agent that runs continuously in the background.
While you have the BlueTree Modem Properties page open, you will
notice a tab labeled Service Control.
You can stop and start the service manually, but this should only be
done by the system administrator.
Starting and stopping the service takes a few moments to complete.
The BlueVue screen will be updated after a brief period.
To stop or start the service:
1.
Click the Service Control tab to access the following screen:
Warning : The default baud rate value for the serial
communication port is 115200 bps (bits per
second). The number of data bits, parity and
number of stop bits are permanently set to 8N1
respectively. Modifying the baud rate, number of
data bits, parity and stop bit parameters for the
serial communication port will prevent the modem
from operating correctly.
During the software
installation process the
modem has been
installed and attached to
a COM port. You do not
need to change the COM
port settings unless you
manually install the
modem on another serial
port.
Caution : The following information is intended for system
administrators. Under normal operating conditions, you do
not need to access the Service Control tab.