Blue Coat SG510 Series, Installation Manual

Page: 35 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 35
transactions), refer to the Blue Coat ProxySG Configuration and Management Guide
Suite .
5.1.1.x—To Configure the SG510 Using the Setup Wizard
Before starting this procedure, ensure that you have met all requirements
described in
“Requirements” on page 29.
1
Place the SG510 into the network.
For information on placing the SG510 into the network, see “Placing the SG510
into the Network” on page 28.
2
Power on the SG510.
3
Use the front panel or serial console to configure the SG510 IP address,
netmask, gateway address, and DNS address.
4
Enter the following URL into your browser:
https://
IP_Address
:8083/
In the preceding URL, IP_Address is the IP address you configured in Step 3.
A security warning dialog appears.
Note: The appearance of the dialog varies depending on the browser that
you use.
5
Click
Yes
(or
OK
) in the dialog.
Important: If you do not see the warning dialog or if you cannot connect to
the Initial Configuration page, see
“The Initial Configuration Page is
Not Accessible”
on page 78.
When the appliance connects, the Setup Wizard displays, as shown in the
following figure.