Blue Coat SG510 Series, Installation Manual

Page: 64 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 64
Logging on to the SG510 CLI
You can connect to the SG510 CLI (a) by using a direct serial connection or (b) by
using an SSH client, such as PuTTY or F-Secure. To connect to the SG510 CLI using
Telnet, you must first enable the Telnet-Console. Refer to the
Volume 3: Proxies and
Proxy Services of the Blue Coat ProxySG Configuration and Management Guide Suite .
Note: The CLI uses two passwords: The console password is required to
establish a connection to the interface, and the enable password
can be set to restrict access to the privileged mode configuration
options. If you forget the username or password, you can reset them
using either the front panel control buttons and LCD or a serial
terminal or PC.
Using a Direct Serial Connection to Connect to the SG510 CLI
1
To set up the serial connection, complete steps 1 and 2 in the section “Initial
Configuration Using a Direct Serial Port Connection” on page 38.
2
After the system has finished booting, press the computer keyboard Enter key
three times. The following text displays:
Welcome to the Appliance Serial Console
Version: SGOS 4.2.2.0, Release id: 12345
------------------------- MENU---------------------------
1) Command Line Interface
2) Setup Console
--------------------------------------------------------
Enter option:
3
Enter
1
to select the Command Line Interface option.
4
Enter the username and password when prompted. If the username has not
been changed, the default is
admin
. The password is the one you wrote down
or configured during initial configuration.