Blue Coat SG510 Series, Installation Manual

Page: 65 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 65
5
At the command prompt, enter
enable
, then enter the enable password that
you wrote down or configured during initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.
6
At the privileged-mode command prompt, enter
configure terminal
to
configure SG510 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide Suite for
information about configuring and administering the ProxySG.
Using an SSH Client to Connect to the SG510 CLI
1
Start the ProxySG.
Note: You must already have an SSH Client installed before you proceed
with the steps below.
2
Launch your SSH Client—enter the following settings as necessary:
• The IP address that you configured during initial configuration.
• A port number, if necessary. (Port 22 is the default.)
• The username and password. If the username has not been changed, the
default is admin. The password is the one you wrote down or configured
during initial configuration.
3
At the command prompt, enter
enable
, then enter the enable password that
you wrote down or configured during initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.