Blue Coat SG510 Series, Installation Manual

Page: 51 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 51
WARNING! If you set the serial console password and then lose the
password, you must restore the appliance to its original factory
defaults to access the Management Console or CLI (see
“Resetting the SG510 to Factory Defaults” on page 81).
Figure 2-18: Initial Setup—Secure the Serial Port (Optional)
8
(Optional) On page 4, you can restrict access to the SG510.
Note: For maximum security, you should restrict physical access to the
SG510.
Do you want to secure the serial port? Y/N [Yes] Y
Enter setup password: ”******”
Verify setup password: ”******”
WARNING:
If you continue and enable the secure serial port it
will not be possible to enter the setup console without
the setup password. If the setup password is lost,
assistance from Blue Coat Systems will be required and
all system configuration may be lost. It is recommended
that this password be stored in a physically secure
location. Access to the CLI on the serial port will
challenge for credentials.
To enable the secure serial port, re-enter the setup
password: ”******”