Blue Coat SG510 Series, Installation Manual

Page: 11 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 11
Figure 1-3: SG510 Attached to a Telco Equipment Rack
Attaching the Cable Management Support
The cable management support routes network serial cables to avoid tangling.
Fasten the cable management support to the back of the system as follows:
1
Position the cable management support at the back of the system on the right;
secure it with a 6-32 x 1/4 flathead screw at the side.
Figure 1-4: Attach the Cable Management Support
When you attach cables to the system, run them through this clip to keep
them from tangling.
Use equipment-rack screws
to attach to the SG510 to the
rack
Attach the cable
management support with a
flathead screw