Blue Coat SG510 Series, Installation Manual

Page: 34 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 34
11
Click
Configure Device
.
•
If a dialog appears with the message
Errors Found
, click
OK
and correct the
errors in the Initial Configuration page. Click
Configure Device
again.
•
If a new browser window appears with the message
The initial configuration
was not established
, note the error messages in this window, close it, and
fix the appropriate data in the Initial Configuration page. Click
Configure
Device
again.
•
If a new browser window appears with the message
Proxy SG Initial
Configuration was successful
, you have successfully completed initial
configuration. This window provides details about accessing the SG510
Management Console (such as the Management Console SHA1
fingerprint). Save this information for future reference. Close the new
browser window and the Initial Configuration page.
Figure 2-6: Successful Initial Configuration Page
When you have set the basic networking parameters and connected the SG510 to
the network, you are ready to fully configure the appliance. For a list of all CLI
commands, refer to the
Blue Coat ProxySG Command Line Interface Reference . For
information about configuring and administering the SG510 (including
information about setting policies that will explicitly grant or deny proxied