Blue Coat SG510 Series, Installation Manual

Page: 49 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 49
Figure 2-15: Initial Setup—Page One
5
On page 2, you are asked if you want to finish configuration using the Setup
Wizard.
Figure 2-16: Initial Setup—Page Two
Welcome to the ProxySG Appliance Setup Console
--------------------- (page 1 of 5) --------------------
Press <ESC> at any time to return to the main menu
DIRECTIONS:
This setup console is used to assign IP addresses to the ProxyS
Appliance. After assigning the IP addresses you can connect to
command line interface or Web interface to perform additional
management tasks.
Enter interface number to configure [0:0]:
IP address [0.0.0.0]: 10.25.36.47
IP subnet mask [255.255.255.0]: 255.255.255.0
IP gateway [0.0.0.0]: 10.25.36.1
DNS server [0.0.0.0]: 101.52.23.100
You have entered the following IP addresses:
IP address: 10.25.36.47
IP subnet mask: 255.255.255.0
IP gateway: 10.25.36.1
DNS server: 101.52.23.101
Would you like to change any of them? Y/N [No] N
--------------------- (page 2 of 5) --------------------
A comprehensive Setup Wizard is available if you use your
Web browser. You can either use the Web Setup Wizard or you
can continue the initial configuration using this serial console.
Note that this serial console initial configuration method
contains a subset of the configuration options available in the
Web Setup Wizard.