Blue Coat SG510 Series, Installation Manual

Page: 29 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 29
Section C: Initial Configuration with a Web Browser
This section describes how to configure the SG510 with a Web browser.
Requirements
To configure your SG510 using a browser, you must meet the following
requirements.
• General Requirements
• The browser must support Javascript and Javascript must be enabled.
• The browser must not be proxied. For information about proxied
browsers, see
“The Initial Configuration Page is Not Accessible” on page 78.
• Your SG510 must not already be configured.
Note: If the SG510 has already been configured, you cannot access the
initial configuration page unless you reset the SG510 to factory
defaults as described in
“Resetting the SG510 to Factory Defaults” on
page 81.
• 4.2.2.x Requirements
If the SG510 is running 4.2.2.x or later, you can access the 4.2.2.x initial
configuration Web page using one of the following methods:
• Change the IP address of the PC so that it is on one of the subnets the
appliance uses for initial configuration. See
“4.2.2.x—To Configure the
SG510 Using a Web Browser:” on page 30 for a list of initial configuration
IP addresses.
• On the PC, create a static route to the SG510. Refer to “Creating A Static
Route to the SG510” on page 79 for information about creating a static
route.
• Purchase and install the optional bridging card to deploy the SG510
inline.
• 5.1.1.x Requirements
If the SG510 is running 5.1.1.x or later, you must configure the SG510 IP
address, subnet mask, gateway, and DNS address using the front panel or
serial console before accessing the Setup Wizard.