11
AQT8 Series
User Manual
Open a web browser on your computer (Chrome or Firefox is recommended)
and enter the following URL address
(http://172.16.70.1). The “Log In” screen
(Figure 4.2a) will appear.
Enter the following case-sensitive factory-default Username and Password, and
click on the [
LOG IN] button.
NOTE:
When logged in as Admin, the user has read and write permission. Only
one Admin can be logged in at a time.
Username = Admin
(case-sensitive)
Password = pass
(case-sensitive)
1
2
3.4 Accessing the User Interface via the Web Browser
You must complete the steps described in Section 4.1
before proceeding as follows:
Figure 4.2a - “Login” Screen
As shown in Figure 4.2b
, under the “Page Header” the following Navigation tabs and links will appear:
•
Navigation Menu (Left): “Status”, “RF Input”, “Cherry Picking (Transport Stream)”, “2:1 Multiplexing”, “IP Output”, “
RF
Output”, and “EAS Config”
•
Navigation Menu (Right): “Time”, “Log”, “Update” and “System”
•
In addition, in the upper right corner above the navigation, the user can access the “Admin” screen through a link,
alongside the [
LOG OUT] button.
Each Navigation bar tab is described in the subsequent Sections.
Monitoring and configuration of the unit is achieved via a series of web pages as described in the Sections below. The following
read-only information is displayed in a “Page Header” (Figure 4.2b) at the top of each web page:
Name: displays the user-defined name to make identification easier. See Section 11.4, to configure this setting.
Location: displays the user-defined location to make identification easier. See Section 11.4, to configure this setting.
ESN:
displays the unit’s serial number.
Uptime: displays the time elapsed since the last time the unit was turned on.
Version: displays the software version of the unit.
PAGE
HEADER
{
Figure 4.2b - Page Header and Navigation
3.3 Setting up Ethernet Access (Continued)
(e) A dialog box entitled ”Internet Protocol Version 4 (TCP/IPv4) Properties” will appear. Select the “Use the following
IP address” option and enter the following addresses:
IP address:
172.16.70.2
Subnet mask:
255.255.255.0
No need to enter a value for the Default Gateway.
Click OK to close the dialog box. Your computer is now ready to communicate with the unit.
6
7
