22
MINI-MODEM V.92
Table 3-1. Example of country, command, and result codes.
Country
AT command
Result code
(hexadecimal)
(decimal)
Euro/NAM
AT%T19,0,34 (default)
52
Japan
AT%T19,0,10
16
NOTE
See Appendix D for a complete list of country codes.
3.7 Step 6: Install and Configure Your Software
You may use either the communication program included with your modem or
a third-party program. Communication programs designed for Windows 95 and
above normally do not need to be manually configured, because they obtain
configuration information from Windows. Communication programs designed for
DOS and other operating systems, however, may need to be manually configured
to work with your modem. Though each communication program is different, the
following procedure should work with most of them.
1. Install and run your communication program.
2. Find the dialog box or menu that lets you select your modem. (In Windows
Terminal select Settings | Modem Commands; in HyperTerminal select File |
Properties
| Phone Number; and in PhoneTools select Configure | General
Configuration
| Communication | Change Modem.
3. Choose your modem from the program’s modem list. If it isn’t listed, choose
a generic modem and modify the settings as necessary.
4. Change the modem initialization string, if necessary. The factory-default
configuration works well for most purposes. To load the factory-default
configuration, use AT&F. To load a custom configuration that was saved
using the &W command, use ATZ. For a Macintosh
®
computer, the
initialization string should include the &D0 command. If you do not want
the modem to always answer the phone, add S0=0 to the string. To use Caller
ID with the modem, add S0=2 to the string. (Caller ID information is sent
between the first and second rings, so the phone must ring at least twice
before the modem picks up the line.) Depending on the software, you might
have to end the string with a carriage return character (^M).
