BK Radio P150, Service Manual

Page: 69 / 264

Page 2-54 Service Manual - KNG Portables
installation and programming
Sln
Enter SLN’s (Storage Location Numbers) in the table that correspond
to the CKR’s (Common Key References) of the keys that have been
loaded into the radio with the APCO Project 25 compatible keyloader
unit.
label
Program an alphanumeric label for each active encryption key.
Security
Enable Clear Tx Mode Warning Beep.
If checked, the radio emits an audible tone with each Push-to-Talk when
encryption is disabled.
If unchecked, no warning tone is heard prior to unencrypted transmissions.
otar
Radios that have the factory option support Over-the-Air Rekeying of encryption keys (OTAR).
If checked, Over-the-Air Rekeying is enabled.
If uncheck, Over-the-Air Rekeying is disabled.
Mark the OTAR channel(s) that will communicate with the Key Management Facility (KMF) in the Channels
Screen.
When the radio is operating in Channel Scan, Priority Scan, and Zone Scan, the main zones’s OTAR Scan
Option Channel is used for the OTAR channel. If the OTAR Scan Option Channel is set to “None”, OTAR
will be disabled when any scan mode is enabled.
allow keyset Selection
Allows selection of OTAR keysets via the radio keypad.
disable data registration
This box should be checked on OTAR equipped radios that will be
receiving keys from a Tactial OTAR equipped Source Radio. (See
Tactical OTAR Setup)
Leave unchecked for standard KMF OTAR systems.
tactical otar taB