BK Radio P150, Service Manual

Page: 87 / 264

Page 3-8 Service Manual - KNG Portables
operation
Pick Key Index

1
2
3
ESC ▲ ▼ ENTER
If the “Key Pick List Target” is programmed (see “Target Radio Options” under
“Key Source Radio Configuration”) the pick list target screen is displayed.
Use the Up/Down buttons to select the desired target key slot. This is the key
pick list slot where the target radio will store the transferred key.
Alternatively the key can be selected directly via the keypad by pressing 1-32.
Press the enter key to begin the key transfer.
When the key information has been sent the radio will momentarily display “Key
Transfer Successful”.
k e y
tr a n s f e r
S u c c e s s f u l
cancel ok
If the radio is not programmed for Tactical OTAR operation or is on a non-OTAR
channel the display will read “Non-Tact., OTAR Channel”.
Should the key transfer fail for any other reason a failure message with a two
digit error code will be displayed.
(See table below.)
tactical otar error code table
code description
01
General Failure
02
DTEK Not Found or Not AES
04
MTEK Not Found or Not AES
F0
General Failure during Key Wrap
F1
Key Not Found for Key Wrap
F4
Key to Wrap Key is Not identified as a KEK
receiving keys
OTAR Key Target Radio
Select the channel designated as the OTAR channel to receive the rekey information.
k e y 5
r e c e i v e d
Upon successful key transfer the radio will show the received key’s programmed
label and “Key Received”. The key received message remains displayed until
radio power is cycled.
The radio will operate normally even while the message is displayed.
If the key transfer is unsuccessful no message will be displayed.