SAFETY PRECAUTIONS
DANGER-CAUTION Read and understand all safety information
before using this product. Failure to follow these instructions may
result in electrical shock, explosion, fire which may result in serious
injuries, death or property damage.
• When used correctly, lithium- ion rechargeable batteries provide a
safe and dependable source of portable power. However, if they are
misused or abused, this may result in leakage, burns, fire or explosion,
causing personal injury or damage to other devices.
• Misusing or incorrectly connecting your powerstation go AC may
cause electric shock to users and damage equipment.
• Do not operate in explosive atmospheres such as in the presence of
flammable liquids, gases or dust.
• Remove jump start clamps from vehicle battery after jump starting vehicle.
• Keep your powerstation go AC dry and away from moisture and
corrosive materials. The powerstation go AC should not be used near
water or wet areas such as bathtubs, showers, bathrooms, sinks,
swimming pools or basements.
• Do not expose your powerstation go AC to moisture, water, rain, or snow.
• Keep your powerstation go AC away from heat sources, including
open flames, radiators, stoves, ovens, and any other devices that
product heat.
• The lithium-ion rechargeable battery used in this charging
device may present a risk of fire or chemical burn if mistreated. Do not
expose to fire or excessive temperature. Do not expose to heat above
212°F (100°C) or incinerate.
• In the unlikely event of leakage or explosion use sand or a chemical
fire extinguisher.
• Your powerstation go AC may become warm under extended high
power operation. Do not cover, wrap, or otherwise restrict the
powerstation go AC during operation.
• Do not disassemble your powerstation go AC. There are no user-
serviceable parts inside. Incorrect reassembly may result in shock
or fire hazard.
• Do not drop or subject to strong impacts. Do not operate your
powerstation go AC if it has received a sharp blow, or has otherwise
been damaged in any way.
• Do not puncture, crush or subject to mechanical shock.
• Only charge your powerstation go AC by the specified method with
the specified charging adapter provided with the unit.
• Do not use any non-mophie-branded accessories with the
powerstation go AC. Doing so may cause electric shock to users and
damage equipment.
• The powerstation go AC, along with its accessories, are not toys and
should be kept away from children.
• Make sure the jumper cables are fully plugged into the jump start
output before trying to jumpstart your vehicle.
• Do not touch red (positive) and black (negative) jumper clamps
together at any point.
• Do not insert any foreign object into the ports or openings of your
powerstation go AC.
• Do not clean your powerstation go AC with harsh chemicals, soaps or
detergents. Just wipe the case with a soft cloth.
• Make sure the powerstation go AC’s charging ports do not become
contaminated with lint or other debris. Use a canned-air type of
product periodically to ensure that the port openings are clear.
• Batteries should be recycled or disposed of as per state and
local guidelines.
• Storage: -4°F – 158°F (-20°C – 70°C), Discharge: 14°F – 122°F
(-10°C – 50°C), Charge: 32°F – 113°F (0°C – 45°C)
OPERATING INSTRUCTIONS
Charging Your powerstation go AC
To charge your powerstation go AC, use the provided Wall Charging
Adapter, and plug the DC jack into the charging put. Next, connect the
wall charging adapter into a wall outlet. The powerstation go AC will
automatically begin charging. When the powerstation go AC is fully
charged, all five battery indicator bars will be solid white and the digital
screen will indicate 100% charged. (This could take up to 9 hours).
While charging, the digital screen will illustrate the charge percentage
of the powerstation go AC. When fully charged, disconnect the cable.
NOTE:
The powerstation go AC is designed to charge between 32°F-113°F
(0-45° C). A "TEMP" indicator will be illustrated on the digital display if
the powerstation go AC is attempted to be charged outside of this
temperature range.
JUMP STARTING YOUR VEHICLE WITH
THE POWERSTATION GO AC
1. Plug the jumper cables into the jump start output on the
powerstation go AC.
2. Attach the jumper cable clamps to the vehicle battery.
- Red clamp on positive terminal (+)
- Black clamp on negative terminal (-)
CHARGING AN ELECTRONIC DEVICE USING
5V/2.4A USB OUTPUT PORT
1. Connect the USB-C tip of the supplied USB-C cable into the
USB-C input of your electronic device and connect the Standard
USB end of the supplied USB-C cable into either one of the
powerstation go AC USB 5V/2.4A Output ports.
2. Turn on the USB charging by pressing the
USB Power ON/OFF Button on the powerstation go AC.
SPECIFICATIONS
Battery Cells:
Contains a battery with 3x Li-Polymer 5000mAh
Battery Pack Energy:
55500 mWh
Jump Start:
12V/600Amps
Input:
14V/0.85A
USB Output:
2x USB 5V/2.4A
Dimensions:
3.82 x 7.17 x 1.5 inches
Weight:
1.66 lbs
Operating Temperature (During Charging) 32°F - 113°F (0°C - 45°C)
Operating Temperature
14°F - 122°F (-10°C - 50°C)
COMPLIANCE WITH FCC REGULATION
This device complies with part 15 of the FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device must be used with
certified peripherals and shielded cables. All peripherals must be
shielded and grounded. Operation with non-certified peripherals or
non-shielded cables may result in interference to radio or reception.
LIMITED WARRANTY
At mophie, we are dedicated to making the best quality products. To
back this up, this product is warranted for 90 days. For full details
regarding warranty terms, exclusions and limitations, please visit:
mophie.com/warranty. This warranty does not affect any statutory
rights that you may be entitled to. Keep a copy of your purchase receipt
as proof of purchase. Be sure to register your product at mophie.com.
MOPHIE SMART CHARGE TECHNOLOGY
Your powerstation go AC contains the mophie SMART CHARGE
TECHNOLOGY to achieve higher compatibility for charging standard 5V
USB electronic devices. The mophie SMART CHARGE TECHNOLOGY will
allow the powerstation go AC to communicate with your electronic
device and provide the fastest and safest charge for that device.
COMPATIBILITY
Standard 5V USB electronic devices including: Mobile phones, Tablets,
PSP, NDS, MP3, MP4, MP5, Bluetooth, GPS, Cameras, and more.
USING YOUR POWERSTATION GO AC FLOODLIGHT
The floodlight can be turned on and off by simply pressing and
releasing the floodlight ON/OFF button. The first press will turn on the
floodlight. Second press will turn on the red emergency light. Third
press will turn on SOS flashing red light. The floodlight will
automatically turn off after 2 hours of inactivity.
JUMP START TROUBLESHOOTING TIPS
3. Press the “Jump Start” button and wait for solid green light.
4. Start your vehicle.
5. Disconnect the jumper cable clamps from the car battery.
powerstation
®
go AC
OPERATING INSTRUCTIONS
powerstation go AC
Thank you for choosing mophie!
Powerful and loaded with features including a new, easy to use digital
display, the powerstation go AC can be used to safely jump start your
vehicle or provide portable power for your AC appliances. The
powerstation go AC can charge your laptop, phone, tablet and other
electronic devices anywhere! The powerstation go AC also includes a
convenient floodlight and emergency light. Compact, versatile and
simple to use, the powerstation go AC and all accessories fit neatly in its
carrying pouch and is perfect to store in your home or vehicle for every
day use or an emergency need.
TABLE OF CONTENTS
Safety Precautions
Included Items
Operating Instructions
Troubleshooting Guide
Specifications
Warranty and Contact Information
