Veterinary monitor user’s manual
Chapter 5-2
Warning: All the electrodes and conducting part shall not be into contact with
any other conductors including the ground. For the sake of patient safety, all the
leads on the ECG cables must be attached to the patient.
Warning: When conducting defibrillation, it is imperative to only use the
electrodes recommended by manufacturer.
Warning: Do not come into contact with the patient, bed and the monitor
during defibrillation.
Warning: The monitor cannot be directly applied to heart and cannot be used
for the measurement of endocardio ECG.
Note: When several parts of equipment are interconnected, the total leakage
current is limited to the safety range according to standards IEC 60601-2-27.
5.1.3 Preparatory Steps before the Measurement of ECG/HR
1) Plug the ECG cable into the ECG socket of the monitor.
2) Place the electrodes onto the body of the patient and connect them to the relevant
lead wires of the ECG cables, and at this moment ECG waveforms will appear on the
screen.
3) Set the parameters relevant to ECG monitoring.
5.1.4 Connecting the ECG Cables to the Monitor
Monitor is provided with three different ECG cables relevant to 3-Lead ECG module,
5-Lead ECG module:
Fig. 5-1-1 Connect the ECG cable to the monitor
1)
3-lead ECG cable
Including three limb leads: RA, LL, and LA.
Relevant ECG socket ECG1 (
It can only be connected to this socket and can not
5-lead ECG cable
CH1
RA
LA
LL
3-leadsECGmonitoring
3-lead ECG cable
CH1
R
A
RL
LA
V(V
4
)
LL
7-leads ECG monitoring