42
BINKS EMS | OPERATION MANUAL
1. To change colors, the initial color must be loaded by following
10.3 Loading a Color Procedure
.
2. Press the Color button on the Pendant for the color loading screen.
3. Enter the color number desired, and press Go to load the color. The system will proceed to flush the gun(s) in
sequence and then load the desired color at the mix ratio for that color.
4. The color selected should be loaded, completing the color change procedure.
10.3 Loading a Color
1. Follow steps 1 through 8 of
10.2 Daily Start Up
Procedure
.
2. Go to the Home screen and verify the unit is in
MIX mode. Ensure atomizing air is turned off. For
systems with gun flush boxes, place the gun in the
box and close the lid.
3. Press the Color button on the Pendant to access the
Color Change screen.
4. Press the color number desired, and press Go to
load the color. When loading a color if the current
color is 0, the fluid lines will not be flushed,
since it is assumed there is no material in the
lines following the
10.5 End of Day Flushing
Procedure
.
NOTE
For a color change, the Go button will not display if:
• The spray gun(s) are not in the Gun Box(es).
• The Gun Box lids are not closed.
• The system is in Standby mode.
5. The color should be loaded and ready to spray.
If adjustments need to be made to the flush
sequence, go to
10.6 Flushing Setup
.
10.4 Color Change Procedure
When taking a short break, the Binks EMS can be placed into a standby mode. Follow the procedure below. For longer breaks,
see
10.8 System Depressurization Procedure
.
1. If Pot Life time is short, clear fluid lines of mixed material. Load Color 0. Refer to
10.3 Loading a Color
.
2. Turn the Utility Switch on the system to Standby mode. For extended shut down procedures, refer to
10.7 End
of Day Flushing Procedure
or
10.8 System Depressurization Procedure
.
10.5 Standby Procedure
