22
BINKS EMS | OPERATION MANUAL
8.3
Color Change Screen
8.4
Usage Screen
This is the only screen other than the HOME
screen that is accessed directly via a Pendant
button. This screen is used for changing colors
and / or flushing the system with the flush / load
sequences programmed into the system from the
accompanying SETUP screens. The Utility switch
must be in MIX mode to use the functions on this
screen.
Accessed via the Home screen, this screen is used to track
the usage of resin and hardener, sorted by color number. It
tracks the volume in cc’s through the flow meter and the
calculated volume of hardener dispensed by the Dispense
Pump. Colors and associated counts will only show for the
colors that have been set up in the system. If the solvent
meter is installed it will be visible at the bottom of this list.
In order for the usage totals to be saved before the system
is powered down, this screen must be accessed. Once it is
accessed, the values will automatically be saved and the
Binks EMS can be powered down.
1. Current Color
This is the current color
loaded in the system.
2. New Color
This is the field where the
next color number to load is entered.
3. GO
The button used to start the color
load process. The loading will begin with
the color selected under New Color.
1. Resin
The total count of resin for the
individual color. Measured in cc’s.
2. Hardener
The total count of hardener
for the individual color. Measured in cc’s.
3. Description
The description of which
color and the corresponding amount
of resin and hardener. Colors may be
present but will not be used if the system
is not equipped. Solvent will be present
at the bottom of this list if ordered with
the Optional Solvent Meter
4. CLEAR
The button used to reset the
usage totals.
2
1
3
1
2
4
3
