iv
WARNING
Do not remove the cover while power is applied or the unit is in operation.
Do not operate the drive with the front cover removed. Electric shock can occur due to
the exposed terminals and bus bars.
Do not remove the cover except for periodic inspections or wiring, even if the input
power is not applied. The capacitor bank may remain charged for some time even when
power is not applied.
Wiring and periodic inspections should be performed at least 10 minutes after
disconnecting the input power and after checking that the DC link voltage is discharged
with a meter (below 30VDC).
CAUTION
Install the drive on a non-flammable surface. Do not place flammable materials nearby.
Disconnect the input power if the drive has been damaged. Do not apply power to a
damaged drive or to a drive with parts missing.
Do not connect a resistance directly between the DC Bus terminals (P1 (or P2)) and N.
Doing so can result in overheating and damaging the resistor.
After shutting down or disconnecting the drive, the drive may be hot to the touch.
Verify that the power-up restart feature is off during servicing to prevent any
unexpected operation.
Do not allow lint, paper, wood chips, dust, metallic chips or other foreign material into
the drive.
Summary of Contents for RSi SG Series
