BENSHAW RSi SG Series, Instruction Manual

Page: 131 / 218

Chapter 6 - Parameter Description [I/O]
6-43
I/O-20~27: Multi-function Input Terminal ‘M1, M2,
M3’, ‘M4’, ‘M5’, ‘M6’, ‘M7’, ‘M8’ Define



The multi-function input terminals can be defined for
many different applications. The following table shows
the default settings for terminals M1 through M8.
Param LCD display Default Setting
I/O-20 M1 define SPEED-L See the
table to the
right
I/O-21 M2 define SPEED-M
I/O-22 M3 define SPEED-H
I/O-23 M4 define Reset
I/O-24 M5 define BX
I/O-25 M6 define JOG
I/O-26 M7 define FX
I/O-27 M8 define RX
Note: BX is the Drive Disable function. When
activated (On), parameter changing is disabled.
The following table shows the various functions that
can be programmed (I/O-20 ~ I/O-27) for terminals
M1 through M8.
LCD
Setting Range
Description
Speed-L Multi-step speed - Low
Speed-M Multi-step speed - Mid
Speed-H Multi-step speed - High
XCEL-L Multi-accel/decel - Low
XCEL-M Multi-accel/decel - Mid
XCEL-H Multi-accel/decel - High
Dc-brake DC injection braking during stop
2nd Func Exchange to 2
nd
functions
Exchange Exchange to commercial line
-Reserved- Reserved for future use
Up Increase Speed
Down Decrease Speed
3-Wire 3 wire operation
Ext Trip External trip
Pre-heat Motor Pre-heat function
iTerm Clear Used for PID control
Open-loop
Exchange between PID mode and V/F
mode
Loc / Rem Local or Remote start control
Analog hold
Hold the analog command frequency
input signal
XCEL stop Disable Accel and Decel
P Gain2 Used for PID P2 gain control
-Reserved- Reserved for future use
Interlock1
Used for MMC operation
Interlock2
Interlock3
Interlock4
Speed-X
Additional Step frequency selection
Reset Reset a fault
BX BX (Drive Disable)
JOG Jog
FX Forward
Run/Stop
RX Reverse Run/Stop
Ana Change Analog input Switch-over
Ext.PID Run Ext PID Control On / Off
Up/Dn Clr Clears the saved frequency when
Up/Down functions are used.
Note: If any two terminals are programmed to the
same function, the drive will display the flashing
message “Over Lap”.
I/O ► M1 define
20 Speed-L
Factory Default:
Speed-L
I/O ► M2 define
21 Speed-M
Factory Default:
Speed-M
I/O ► M3 define
22 Speed-H
Factory Default:
Speed-H