4
126305 Rev B 05/22/15
Powering up the Module:
The module receives its power through the Power Supply.
There are no power switches on the module. The only way
to power on or off the module is by using the Circuit Breaker.
The Bennett Logo will appear for approximately 5 seconds
when power is applied to the unit (see figure 1.1) .
After the Bennett Logo is displayed the screen will display
the “Please Pay Inside” message.
NOTE:
“Please Pay Inside” will be displayed only if the
module and/or POS (Point of Sale) has not been
configured or installed at this time (see figure
1.2). The message will return if the POS does not
send a message to the module for 60 seconds.
Idle Screen:
Once everything is installed, programmed and configured
properly (see installation section) the module should be
ready to use. The idle screen of the module will prompt the
user to either “Pay Here Credit” or “Pay Inside” (see figure
1.3).
FIGURE 1.1
-
Bennett Logo
FIGURE 1.2
-
“Please Pay Inside”
Introduction
FIGURE 1.3
-
Idle Screen
